Denon AVR-987 iChecking and storing the measurement results Press DDHHto select the item, then press ENTER., After checking, press ENTER, then press DDHHto, When Store is selected: Press FF., Error messages

Measures
Cause
Example
12
Easy Setup Procedure Easy Setup Procedure
iChecking and storing the measurement
results
Press DDHHto select the item, then press ENTER.
Press ENTER to switch to the second screen.
The measurement results displayed at “uSpeaker measurements”
can be checked and stored in the memory.
1
Store:
All the settings are stored in the memory.
After checking, press ENTER, then press DDHHto
set.
When “Store” is selected:
Press FF.
•After the data is stored, the “Auto Setup / Room EQ”
screen appears automatically.
Cancel:
Cancel the auto setup settings.
•When measurements have been made using the measurement
microphone, speakers with a built-in filter such as subwoofers
might be set with a value that differs from the physical distance
because of the internal electrical delay.
NOTE:
•Do not turn off the power while the data is being stored.
2
3
1
2
qThe speakers required for producing suitable
reproduction have not been detected.
If multiple errors occur, press FFGGto check the
contents.
•Check that the pertinent speakers are properly
connected.
wThe speaker polarity is connected in reverse.
If multiple errors occur, press FFGGto check the
contents.
•Check the polarity of the pertinent speakers.
•For some speakers, the screen below may be
displayed even though the speakers are
properly connected.
If so, select “Skip
0 ”.
eThere is too much ambient noise in the room and the
measurements cannot be made accurately.
rThe sound level that is output from the speakers and/or
subwoofer is too low.
•Either turn off the power of the device that
generated the noise during the measurements
or move the device away.
•Try again at a time when it is quieter.
•Check the placement and orientation of the
loudspeakers.
•Adjust the subwoofer’s output level.
tThe measurement microphone is not connected, or all
of speakers have not been detected.
•Connect the attached setup microphone to
<SETUP MIC>.
•Check the speaker connection.
Error messages
An error message is displayed if the measurements could not be completed automatically due to the speaker layout, the measuring
environment, etc. Please check the following matters, reset the pertinent items, and measure again.
Be sure to turn off the AVR-987’s power before checking the speaker connections.