Denon AVR-987 FFto select Yes., -1, -2

58
Advanced Setup – Part 2 Advanced Setup – Part 2
Press DDHHto select the speaker, then press FFGG
to set.
3
Press ENTER.
4
12
3
Set the volume of the various speakers so that the sound output
from the speakers and the subwoofer seems to have the same
volume level.
Press DDHHto select “Channel Level”, then press
ENTER.
Press DDHHto select “Test Tone Start”, then press
FFto select “Yes”.
Press FFGGto set.
When “Auto” mode is selected:
Press FFGGto adjust the volume.
•Test tones are output automatically, in the order shown
below.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output
switched manually.
FL
SW
CFR SR
SBL
SL
SB
SBR
Setting the Channel Level
The volume can be adjusted within the range –12 dB to +12
dB.
When “Manual” mode is selected:
Press DDHHto select the speaker, then press FFGG
to adjust the volume.
Press ENTER.
1
2
3
4
-1
4
-2
5
(2 speakers)
(1 speaker)
123
4
-1 4
-2
•To cancel the setting, press HHand select “Level Clear”, then
press FFand select “Yes”.
•To adjust the channel level separately for the different play
modes after setting the channel level, perform the operation on
page 34.
•Press DDto select “Step”, then press FFGGto change the
amount of variation if so desired.
•The distance changes in units of 1 foot (0.1 meters) or 0.1 foot
(0.01 meters) each time the button is pressed. Select the value
closest to the measured distance.
•Please note that the difference of distance for every
speaker should be 20 ft (6.0 m) or less. If you set an invalid
distance, a CAUTION notice, such as screen right will
appear. In such cases, move the appropriate speaker to the
position of the displayed value.
.....L1
.....L2
.....L3
.....L4
.....L5
.....L6
.....L7
.....L8