ENGLISH

Getting Started

Accessories

Check that the following parts are attached in addition to the main unit:

q Operating instructions .............................................................

1

w Service station list....................................................................

1

e Remote control unit (RC-1028)

................................................

1

r R03/AAA batteries ...................................................................

2

t Pin-plug cable (Cable length: Approx. 1.0 m)...........................

1

e

r

t

Before using
• Handle the power supply cord carefully.

Do not damage or deform the power supply cord. If it is damaged or

deformed, it may cause electric shock or malfunction when used.

When disconnecting the power supply cord from the wall outlet,

hold the plug and do not pull on the cable.

• Do not open the top cover.

In order to prevent electric shock, do not open the top cover.

If problems occur, contact your DENON dealer.

• Do not place anything inside.

Prevent metal objects from entering the CD player and avoid spilling

liquids on it.

Electric shock or malfunction may result.

• Cautions on moving.

First, if a disc is loaded, eject it, then turn off the power, unplug the

power supply cord from the power outlet and disconnect the

connection cables with other devices.

• Cautions on using mobile phones.

Using a mobile phone near this unit may result in noise. If so, move

the mobile phone away from this unit when it is in use.

Store the operating instructions in a safe place.

After reading the operating instructions, store them in a safe place as they could come in handy in the future.

Note that the illustrations in these instructions may differ from the actual unit for explanation purposes.

NOTE:

This CD player uses a semiconductor laser. To ensure stable operation, it is recommended to use the set indoors at a temperature of 5°C (41°F) ~ 35°C (95°F).

About discsDiscs usable on this setqMusic CDs

Discs with the mark at the right can be used on this set.

Note however that discs with special shapes (heart-shaped discs, octagonal discs, etc.) cannot be played. Do not attempt to play them, as doing so could damage the set.

wCD-R/CD-RW

Some discs and some recording formats may not be playable.

Non-finalized discs cannot be played.

Finalization:

Finalization is the process that makes recorded CD-R/CD-RW discs playable on compatible players.

Getting Started

Loading discs

Set the disc with the labeled side facing up.

Make sure the disc tray is fully open when inserting the disc.

Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1), 8 cm discs in the inner tray guide (Figure 2).

Figure 1

Figure 2

Outer tray guide

Inner tray guide

12 cm discs

8 cm discs

Place 8 cm discs in the inner tray guide without using an adapter.

“NO DISC” is displayed if a disc is loaded upside down or if no disc is loaded.

• Sufficiently ventilate the place of installation.

If the unit is left in a room full of the smoke from cigarettes, etc., for

long periods of time, the surface of the optical pickup could get dirty,

in which case it will not be able to read the signals properly.

Holding discs

Do not touch the signal surface.

2

ENGLISH