Desa 28BN installation manual Tools Required, Assembly, For..com

4

TOOLS REQUIRED ASSEMBLY

TOOLS REQUIRED

•#2 Phillips screwdriver

•9/16" Open end wrench

ASSEMBLY

Assemble the heater in the approximate location it will be used to minimize moving heater once assembled.

1.Position base on floor with open side down.

2.Locate right wrapper and left wrapper. Place one side to base and secure using 5 screws provided. Repeat for other side (see Figure 2).

3.Locate center wrapper. The center wrapper is angled at the bottom and has a hole on either side of the front at the top. Slide J-clips over holes on open side of center wrapper with short side to the outside of center wrapper (see Figure 3).

Left

Wrapper

Right

Wrapper

Screw

Base (Front)

4.Align holes on center wrapper with holes on left and right wrap- pers. Using screws provided, attach center wrapper to left and right wrappers and base from inside the assembly (see Figure 4).

5.Insert back plate up through the base and wrapper assembly and attach to left and right wrappers with 4 screws provided (see Figure 5). The back plate will be under the wrapper flanges as shown in Figure 5.

Back

Plate

Screw

Base/Wrapper

Assembly

Figure 4 - Attaching Back Plate

Figure 2 - Attaching Left and Right Wrappers to Base

Back Plate	Back Plate Under
	Wrapper Flanges

Short Leg of J-Clip	J-Clips
	Screw
on Outside of Wrapper

Wrapper

Flanges

Center

Wrapper

Base	Base	Figure 5 - Back Plate Location
Angled End
	Assembly

Figure 3 - Attaching Center Wrapper to Base Assembly

For..com

107396