Assembly, Continued, Attaching Lower Mast, Removing

ASSEMBLY

Continued

6.Place lower mast inside base assembly (see Figure 6). Bottom of lower mast has cut out section that slips into base assembly. Us- ing 10 screws provided, attach to base assembly and back plate.

7.Remove 4 screws from control cover on back of upper mast assembly (see Figure 7). Carefully pull control cover from as- sembly and unplug electrode wire from piezo ignitor. The ig- nitor will stay assembled to the control cover.

8.Slide upper mast assembly over lower mast and install using 4 screws provided (see Figure 8).

Lower Mast

		Screw
	Bottom of	Back
	Lower Mast	Back
	Lower Mast	Plate
		Plate

Center	Base Assembly
Wrapper

Figure 6 - Attaching Lower Mast

	Control Cover	Upper Mast
	Screw
		Assembly

	Upper Mast	Screw
	Assembly	Screw
	Assembly
	Electrode
	Wire	Lower
		Lower
		Mast
	Piezo Ignitor
	Figure 7 - Removing	Figure 8 - Attaching Upper
	Control Cover	Mast Assembly

9.Using hose and regulator assembly provided, route hose up through mast from inside base assembly. Screw hose fitting onto inlet of valve and tighten with 9/16" open end wrench (see Figure 9).

10.Using only a 20 lb. propane/LP cylinder, not included (see safety information for proper cylinder selection), connect the hose/regulator assembly to the cylinder (see Figure 10). When connecting regulator assembly to cylinder valve, hand tighten nut clockwise to a positive stop. DO NOT use a wrench to tighten. Use of a wrench may damage quick closing coupling nuts and result in a hazardous condition.

Gas Valve Inlet

Gas Hose/

Regulator

Assembly

Base