Storage, Maintenance, Replacement Parts, Operation, Continued

OPERATION STORAGE MAINTENANCE REPLACEMENT PARTS

OPERATION

Continued

9.Push knob in and quickly press IGNITOR button (see Figure 14). Repeat until heater is lit. This can be easily done by placing index finger in access hole on left of control cover and push- ing ignitor with thumb (see Figure 14).

10.Continue holding knob in for approximately 30 seconds. Heater should remain lit in the LOW heat setting.

11.For more heat, press knob and rotate counterclockwise to HIGH setting.

12.If RELIGHTING, wait 5 minutes for heater to cool and gas to clear, then follow steps 4 through 11.

Control Knob

Access

Hole in

Control Box

Piezo

Ignitor

Figure 14 - Piezo and Control Knob Locations

SHUTDOWN INSTRUCTIONS

1.Press control knob and rotate clockwise to OFF position.

2.Close propane/LP cylinder valve (rotate knob clockwise).

STORAGE

CAUTION: Disconnect heater from propane/LP supply cylinder.

1.Do not store heater while attached to propane/LP cylinder. Close cylinder valve. Remove the hose/regulator assembly from the propane/LP cylinder by turning the fuel gas connector nut clockwise.

2.Store propane/LP cylinder in safe manner. Refer to Chapter 5 of Standard for Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58. Follow all local codes. Always store propane/LP cylinders outdoors. Never store propane/LP cyl- inder in an enclosed area.

3.Store in a dry, clean, and safe place.

MAINTENANCE

WARNING: Never attempt to service heater while it is connected to propane/LP supply, operating, or hot. Severe burns can occur. Any guard or other protective device removed for servicing must be replaced prior to operating the heater.

1.Keep heater clean. Remove any debris from ventilation open- ings (see Figures 12 and 13, page 6).

2.Inspect heater before each use. Check connections for leaks. Ap- ply mixture of liquid soap and water to connections. Bubbles form- ing show a leak that must be corrected. Correct all leaks at once.

3.Inspect hose/regulator assembly before each use. If hose is highly worn or cut, replace it immediately.At least annually, remove hose/ regulator assembly from heater to inspect entire length of hose.

4.Spiders and insects can create a dangerous condition that may damage heater or make it unsafe. Keep burner area clean of all spiders, webs, or insects.

5.Have heater inspected yearly by a qualified service person.

REPLACEMENT PARTS

WARNING: Use only original replacementparts. This heater must use design-specific parts. Do not substitute or use generic parts. Improper replacement parts could cause serious or fatal injuries. This will also protect your warranty coverage for parts replaced under warranty.

PARTS UNDER WARRANTY

Contact authorized dealers of this product. If they can’t supply original replacement part(s), either contact your nearest Parts Cen- tral or call DESA International’s Technical Service Department at 1-866-672-6040.

When calling DESA International, have ready

•your name

•your address

•model and serial numbers of your heater

•purchase date

•how heater was malfunctioning

In most cases, we will ask you to return the part to the factory.

PARTS NOT UNDER WARRANTY

Contact authorized dealers of this product. If they can’t supply original replacement part(s), either contact your nearest Parts Central listed in the Authorized Service Center booklet supplied with heater or call DESA International at 1-866-672-6040 for referral information.

When calling DESA International, have ready

•model number of your heater

•the replacement part number

For morevisit www..com