Desa CDVBPC, CDVBNC Safety Information Product Identification, Cleaning stove or burner system

SAFETY INFORMATION PRODUCT IDENTIFICATION

3

SAFETY INFORMATION

Continued

PRODUCT IDENTIFICATION

5.	This stove reaches high temperatures. Keep children and adults
	away from hot surfaces to avoid burns or clothing ignition.
	Stove will remain hot for a time after shutdown. Allow sur-
	faces to cool before touching.
6.	Carefully supervise young children when they are in the room
	with stove.
7.	Do not modify the burner or stove under any circumstances.
	Any parts removed for servicing must be replaced prior to op-
	erating burner system.
8.	Turn burner system off and let cool before servicing, install-
	ing, or repairing. Only a qualified service person should in-
	stall, service, or repair the stove or burner system. Have burner
	system inspected annually by a qualified service person.
9.	You must keep control compartments, burners, and circulat-
	ing air passages clean. More frequent cleaning may be needed
	due to excessive lint and dust from carpeting, bedding mate-
	rial, pet hair, etc. Turn off the gas valve and pilot light before
	cleaning stove or burner system.

Cast Iron Stove Body

Log Set

	ON	LO H
	OFF	I	OFF
	AUTO
			ON
ON/OFF	Piezo Ignitor		Control
Switch
			Valve

10.	Have venting system inspected annually by a qualified service
	person. If needed, have venting system cleaned or repaired.
	See Cleaning and Maintenance, page 28.
11. Keep the area around your stove clear of combustible materi-
	als, gasoline, and other flammable vapor and liquids. Do not
	run burner system where these are used or stored. Do not place
	items such as clothing or decorations on or around stove.
12. Do not use this stove to cook food or burn paper or other objects.
13.	Never place anything on top of stove.
14.	Do not use any solid fuels (wood, coal, paper, cardboard, etc.)
	in this stove. Use only the gas type indicated on burner system
	nameplate.
15.	This appliance, when installed, must be electrically grounded
	in accordance with local codes or, in the absence of local codes,
	with the National Electrical Code, ANSI/NFPA 70, or the Ca-
	nadian Electrical Code, CSA C22.1.
16.	Do not obstruct the flow of combustion and ventilation air in
	any way. Provide adequate clearances around air openings into
	the combustion chamber along with adequate accessibility
	clearance for servicing and proper operation.
17.	Do not install stove directly on carpeting, vinyl tile, or any com-
	bustible material other than wood. The stove must set on a metal
	or wood panel extending the full width and depth of the stove.
18.	Do not use stove or burner system if any part has been ex-
	posed to or under water. Immediately call a qualified service
	person to arrange for replacement of the unit.
19.	Do not operate burner system if any log is broken.
20.	Do not use a blower insert, heat exchanger insert, or other ac-
	cessory not approved for use with this stove.

21. Do not operate burner system with glass door removed, cracked, or broken.

Cast Iron
Stove Body	Burner

Vent

Opening

Rear

Cover

Pilot
Assy
	Glass
Blower with	Door
	Assy
Adjustment
(Optional
Installation)

Glowing	Grate	Lava Rock
Embers	Assembly

Figure 1 - Comfort Glow Direct-Vent Burner System Shown Installed in Approved Comfort Glow Cast Iron Stove Body Models CISGA Series and CISCA Series Only

For morevisit www..com

105501-01F