General Venting, Installing Rear Cover

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Installing Optional Blower Accessory (Cont.)

Installing Rear Cover

GENERAL VENTING

Location Of Vent Termination

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Continued

WARNING: Failure to position the parts in accor- dance with supplied diagrams or failure to use only parts specifically approved with this stove and burner system may result in damage or personal injury.

8.Connect or reconnect gas supply to stove and burner system per Connecting Stove/Burner System to Gas Supply on page 20 of this manual.

WARNING: A qualified service person must con- nect burner system to gas supply. Follow all local codes.

INSTALLING REAR COVER

1.Lift rear panel over vent pipe connection on burner system. Rear cover will rest on the bottom ledge of the stove body.

2.Using screws provided, attach rear cover to back of stove body. See Figure 17.

IMPORTANT: This rear cover must be securely in place be- fore venting pipes are installed.

GENERAL VENTING

These models are approved for use with Simpson Dura-Vent 6 5/8" direct-vent pipe components and terminations as well as both flex and rigid Comfort Glow vent components.

Your stove with burner system is approved to be vented either through the side wall, or vertically using the following guidelines:

•Only use Comfort Glow or Simpson Dura-Vent GS venting com- ponents or kits specifically approved for this stove and burner system.

•Minimum clearance between vent pipes and combustible mate- rials is 1" (25 mm), except where stated otherwise.

•Do not recess venting terminals into a wall or siding.

•Install horizontal venting with a 1/4" rise for every 12" of run toward the termination.

•You may paint the vent terminal with 450ºF (232ºC) heat-resis- tant paint to coordinate with the exterior finish.

•There must not be any obstruction such as bushes, garden sheds, fences, decks, or utility buildings within 24" from the front of the termination cap.

•Do not locate termination cap where excessive snow or ice build up may occur. Be sure to clear vent termination area after snow falls to prevent accidental blockage of venting system. When using snow blowers, do not direct snow towards vent termina- tion area.

•You must maintain minimum wall and ceiling clearances shown in Figures 3 and 4, page 5.

Rear

Cover