Desa CDVBN(A), CDVBP(A) Connecting STOVE/ Burner System to GAS Supply, Checking GAS Connections

OWNER’S MANUAL

STOVE AND

DIRECT-VENT BURNER SYSTEM INSTALLATION

Continued

CONNECTING STOVE/ BURNER SYSTEM TO GAS SUPPLY

Installation Items Needed

•5/16" hex socket wrench or nut-driver

•sealant (resistant to propane/LP gas, not provided)

1.Open lower door panel.

2.Route flexible gas line (provided by installer) from manual shutoff valve to burner system. Route flexible gas sup- ply line through slot in stove bottom and attach to valve.

3.Check all gas connections for leaks. See Checking Gas Connections.

CHECKING GAS

CONNECTIONS

WARNING: Test all gas pip- ing and connections for leaks after installing or servicing. Cor- rect all leaks at once.

WARNING: Never use an open flame to check for a leak. Apply commercial leak test solution to all gas joints. Bubbles forming show a leak. Correct all leaks at once.

Pressure Testing Gas Supply Piping System

Test Pressures In Excess Of 1/2 PSIG (3.5 kPa)

1.	Disconnect burner system and its
	individual manual shutoff valve from
	gas supply piping system. Pressures in
	excess of 1/2 psig (3.5 kPa) will
	damage burner system gas regulator.
2.	Cap off open end of gas pipe where

To Flare Fitting on Control Valve

Manual Shutoff Valve
	To Gas Supply
Flexible Gas Line from	(Natural)
Manual Shutoff Valve	To External
Provided by Installer
	Regulator
	(Propane/LP)

manual shutoff valve was connected.

3. Pressurize supply piping system by ei-

ther opening propane/LP supply tank

valve for propane/LP gas burner sys-

tem or opening main gas valve located

on or near gas meter for natural gas

burner system, or using compressed air.

4. Check all joints of gas supply piping

system. Apply commercial leak test so-

lution to all gas joints. Bubbles forming

Figure 40 - Flexible Gas Line

show a leak. Correct all leaks at once.

5. Reconnect burner system and manual

shutoff valve to gas supply. Check re-

connected fittings for leaks.

Continued

105501 19