CDVBN(A) AND CDVBP(A)
CAST IRON STOVE AND BURNER SYSTEM
CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
Continued
INSTALLING REAR COVER
1.Lift rear panel over vent pipe connec- tion on burner system. Rear cover will rest on the bottom ledge of the stove body.
2.Using screws provided, attach rear cover to back of stove body. See Fig- ure 17.
IMPORTANT: This rear cover must be securely in place before venting pipes are installed.
Rear
Cover
GENERAL VENTING
These models are approved for use with Simpson
Your stove with burner system is approved to be vented either through the side wall, or vertically using the following guidelines:
•Only use Comfort Glow or Simpson Dura- Vent GS venting components or kits spe- cifically approved for this stove and burner system.
•Minimum clearance between vent pipes and combustible materials is 1" (25 mm), except where stated otherwise.
Screw
•Do not recess venting terminals into a wall or siding.
•Install horizontal venting with a 1/4" rise for every 12" of run toward the termination.
•You may paint the vent terminal with 450ºF (232ºC)
•There must not be any obstruction such
as bushes, garden sheds, fences, decks, or utility buildings within 24" from the front of the termination cap.
•Do not locate termination cap where ex- cessive snow or ice build up may occur. Be sure to clear vent termination area af- ter snow falls to prevent accidental block- age of venting system. When using snow blowers, do not direct snow towards vent termination area.
•You must maintain minimum wall and ceiling clearances shown in Figures 3 and 4, pages 4 and 5.
LOCATION OF VENT
TERMINATION
When locating vent termination, it is impor- tant to observe the minimum clearances shown in Figure 18, page 9.
*Check with local codes or with the current CAN/CGA B149[.1 or .2] Installation Codes for Canada or the USA Installations follow the current National Fuel Gas Code, ANS Z223.1, also known as NFPA 54.
Firebox
Installed In Cast
Iron Stove Body
Figure 17 - Installing Rear Cover
8 | 105501 |
