Installing DIRECT-VENT Burner System Into Stove Body, Door

CDVBN(A) AND CDVBP(A)

CAST IRON STOVE AND BURNER SYSTEM

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Continued

8. Fasten each leg to stove with four (4)

M8 x 1.25 - 20mm bolts. Use a flat

washer and lock washer with each bolt.

10. Attach stove door by inserting step bolt

through door hinge pivot hole and into

threaded hole in stove body (see Figure

9, page 5 and Figure 10). Use an adjust-

able wrench or a 12mm socket to fasten

step bolt. Tighten step bolt until snug.

Make sure door moves freely.

11. Install door catch bolt (M8 x 1.25-

55mm with two M8 hex nuts) into

threaded hole on stove body (see Fig-

ure 9, page 5). Use an adjustable

Door Claw

Door

Bolt Stop

Adjusting Nut

Catch Bolt

Tighten bolts into threaded holes on

stove body (see Figure 9, page 5 and

Figure 10). Use an adjustable wrench

or a 12mm socket.

9. Fasten stove bottom to stove with four

(4) M6 x 1 - 25mm bolts. Use a flat

washer and lock washer with each bolt.

Tighten bolts into threaded holes on

stove body (see Figure 9, page 5 and

Figure 10). Use an adjustable wrench

or a 10mm socket.

wrench or a 12mm socket. The catch

bolt has two hex nuts attached to it

(see Figure 13). The top nut is a bolt

stop and the bottom nut is for door

leveling adjustment.

12. Check general catch bolt alignment

with door claw. Make final adjustment

and door leveling after stove is in nor-

mal standing position.

13. Carefully lift stove back up on its four

attached legs.

Figure 13 - Catch Bolt and Door Claw Orientation