FINISHING
Combustible Finishing Material : Materials made of or surfaced with wood, compressed paper, plant fibers, plastics or any material capable of igniting and burning, whether flame proofed or not, plastered or unplastered (this includes drywall).
Noncombustible Finishing Material : Mate-
rials which will not ignite and burn. Such materials are those consisting entirely of steel, iron, brick, tile, concrete, slate, glass or plasters or combina- tions thereof or have a fire rating of zero.
WARNING:Grillsonthisheater cannot, in any way, be covered as it may create a fire hazard,
FINISHING CHECKLIST
•Power supply service must be completed prior to finishing to avoid reconstruction.
•Grilles and air openings cannot be covered in any circumstances.
Note: The heater is a zero clearance fireplace and may be finished with combustible or noncombus- tible finishing materials.
When using paint or lacquer to finish the mantel, they must be heat resistant to prevent discoloration.
OPERATING
INSTRUCTIONS
The controls (see Figure 4) are located behind the grill above glass panel and can be accessed by pulling the grill from the top, forward and down.
Heater Temperature
Control Dial | Heater ON/OFF |
| |
| Power Switch |
Display ON/OFF Knob | |
Backlight Control Knob | |
Figure 4 - Controls For Electric Fireplace
1.Main ON/OFF power switch: This switch is located at the furthest right corner on the control panel. Turn the switch to ON and unit will be ready to operate. The ""
indicates ON and "O" indicates OFF.
IMPORTANT: Once you turn the main switch to the ON posi- tion, the remote control can no longer be used. In order to use the remote control, you must keep the main ON/OFF switch in the OFF.
2.Display ON/OFF knob: There is a flame icon directly below this knob. After you turn the Main Power switch to the ON position, turn the Display Knob to desired setting. Both the logset and the flame will light up inside the fireplace
3.Heater Switch and Control Dial: The dial is located to the furthest left on the front panel with a temperature icon directly below it. To turn the heater on, flip the Heater Switch to ON position (the "" indicates ON and "O" indicates OFF) then turn the dial clockwise past the number 8. You should hear a small clicking sound indicating the heater has started and heat will emit through the vents located in the middle of the control panel. To turn off heater, turn the temperature dial counter clockwise past number 1 and flip the Heater Switch to OFF position. Heat will stop coming out of the vent.
To increase the desired temperature, turn the temperature dial clockwise towards Number 8.
To decrease the desired temperature, turn the temperature dial counter clockwise towards number 1. The heater has
Note: When the heater is turned on for the first time, it may release a slight, harmless odor. This odor is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again.
4.Backlight Control Knob: The backlight control knob allows you to brighten or dim the light that shines on the logs.
OPERATING BY REMOTE CONTROL
1.Plug in your electric fireplace and it will beep once. This means you have power and your remote is ready to operate your electric fireplace.
www.desatech.com | 7 |
