INSTALLATION
Continued
OPTIONAL WIRELESS
Installing Receiver
1.Remove screws.
2.Disconnect switch wires from the con- trol valve.
3.Remove switch plate (see Figure 22). Discard switch plate after removing. Save the screws.
4.Locate the battery clip mounted on the back of the receiver (see Figure 23).
5.Slide
6.Attach the terminal wires to the battery (see Figure 23).
7.Connect wires as shown in Figure 24.
8.Install remote receiver unit onto gas heater base using the two screws re- moved in step one (see Figure 24).
Screw
Switch Plate
Red Wire
Black Wire
Heater Base
Figure 22 - Switch Plate and Wiring Harness
Receiver
Terminal
Wires
Battery Clip
Figure 23 - Attaching Battery to Receiver
Remote
Receiver
Black Wire | Red Wire |
|
Wire Harness*
Wires from
Valve
Black Wire
Red Wire
Figure 24 - Installing Remote Receiver
*Wire harness provided in the fireplace hardware pack.
Installing
1.Remove battery cover on back of re- mote control unit.
2.Attach terminal wires to the battery (not included). Place battery into the battery housing.
3.Replace battery cover onto remote con- trol unit.
Battery Remote
Terminal CoverControl Unit
Wires
Battery
Housing
Figure 25 - Installing Battery in Hand- Held Remote Control Unit
14 | 105616 |