Desa CGN10L, CGN6L installation manual Checking, Pressure Testing Heater GAS Connections

CHECKING	4.	Check all joints of gas supply piping system. Apply mixture of liquid soap and
GAS		water to gas joints. Bubbles forming show a leak.
	5.	Correct all leaks at once.
CONNECTIONS	Test Pressures Equal To or Less Than 1/2 PSIG
Continued	1.	Close manual shutoff valve (see Figure 13).
	2.	Pressurize supply piping system by either using compressed air or opening main
		gas valve located on or near gas meter.
	3.	Check all joints from gas meter to manual shutoff valve (see Figure 14). Apply
		mixture of liquid soap and water to gas joints. Bubbles forming show a leak.
	4.	Correct all leaks at once.
	PRESSURE TESTING HEATER GAS CONNECTIONS
	1.	Open manual shutoff valve (see Figure 13).
	2.	Open main gas valve located on or near gas meter.
	3.	Make sure control knob of heater is in the OFF position.
	4.	Check all joints from manual shutoff valve to control valve (see Figure 14).
		Apply mixture of liquid soap and water to gas joints. Bubbles forming show a
		leak.
	5.	Correct all leaks at once.
	6.	Light heater (see Operating Heater, pages 16 through 18). Check the rest of the
		internal joints for leaks.
	7.	Turn off heater (see To Turn Off Gas to Appliance, page 18).
	8.	Replace front panel.
						N
					Open
		Manual	POSITION
		Shutoff
		Valve
						OFF
					POSITION
				Closed
		Figure 13 - Manual Shutoff Valve
			Control Valve Location

Gas Meter

Manual

Shutoff

Valve

Figure 14 - Checking Gas Joints

15

103546