18
OPERATING HEATER
Continued
INSPECTING BURNER
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater |
|
|
|
| |
1. | Turn control knob clockwise | Clockwise | to the PILOT position. | ||
2. | Press in control knob and turn clockwise | Clockwise | to the OFF position. | ||
Shutting Off Burner Only (pilot stays lit)
1. Turn control knob clockwise Clockwise
to the PILOT position.
MANUAL LIGHTING PROCEDURE
1.Remove front panel (see Figure 10, page 12).
2.Follow steps 1 through 5 under Lighting Instructions, pages 16 and 17.
3.With control knob pressed in, strike match. Hold match to pilot until pilot lights.
4.Keep control knob pressed in for 30 seconds after pilot is lit. After 30 seconds, release control knob.
5.Replace front panel.
Check pilot flame pattern and burner flame pattern often.
PILOT FLAME PATTERN
Figure 17 shows a correct pilot flame pattern. Figure 18 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the thermocouple. This will cause the thermocouple to cool. When the thermocouple cools, the heater will shut down.
Pilot Burner
Thermocouple
GOOD PILOT | GRH/OV 009 |
Figure 17 - Correct Pilot Flame Pattern
Thermocouple | Pilot Burner |
|
BAD PILOT | GRH/OV 010 |
Figure 18 - Incorrect Pilot Flame Pattern
If pilot flame pattern is incorrect, as shown in Figure 18
•turn heater off (see To Turn Off Gas to Appliance, above)
•see Troubleshooting, pages 20 through 23
Continued
103546
