Desa RP30C Operating, Inspecting, Burner, To Turn Off Gas To Appliance, Manual Lighting Procedure

OPERATING			TO TURN OFF GAS TO APPLIANCE
HEATER
	Shutting Off Heater
Continued	1. Turn control knob clockwise Clockwise to the PILOT position.
	2.	Press in control knob and turn clockwise Clockwise to the OFF position.
	3.	Turn off all electric power to the appliance if service is to be performed.
	Shutting Off Burner Only (pilot stays lit)
	1.	Turn control knob clockwise Clockwise to the PILOT position.

			MANUAL LIGHTING PROCEDURE
	1.	Remove front panel (see Figure 5, page 11).
	2.	Follow steps 1 through 5 under Lighting Instructions, pages 17 and 18.
	3.	With control knob pressed in, strike match. Hold match to pilot until pilot
		lights.
	4.	Keep control knob pressed in for 30 seconds after lighting pilot. After 30
		seconds, release control knob.
INSPECTING	5.	Replace front panel.
	Check pilot flame pattern and burner flame pattern often.
BURNER	PILOT FLAME PATTERN
	Figure 18 shows a correct pilot flame pattern. Figure 19 shows an incorrect pilot
	flame pattern. The incorrect pilot flame is not touching the thermocouple. This will
	cause the thermocouple to cool. When the thermocouple cools, the heater will shut
	down.

Pilot Burner

Thermocouple

Figure 18 - Correct Pilot Flame Pattern

Pilot Burner

Thermocouple

Figure 19 - Incorrect Pilot Flame Pattern

Continued 19

101805