Desa CGS10P Thermostat Control Operation, Propane/Lp Gas Heater, Operating Heater, Continued

Models: CG10P CG6P CGS10P

1 26
Download 26 pages 22.09 Kb
Page 12
Image 12
THERMOSTAT

PROPANE/LP GAS HEATER

OPERATING

HEATER

Continued

THERMOSTAT MODEL CGS10P

FOR YOUR SAFETY

READ BEFORE

LIGHTING

Manual background WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas sup- plier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas con- trol which has been under water.

LIGHTING

INSTRUCTIONS

1.STOP! Read the safety information in column 1.

2.Make sure equipment shutoff valve is fully open.

3.Turn control knob clockwise Manual background to the OFF position (see Figure 19).

4.Wait five (5) minutes to clear out any gas. Smell for gas around heater and near floor. If you smell gas, STOP! Follow “B” in the safety information in column 1. If you don’t smell gas, go to next step.

5.Turn control knob counterclockwise

Manual background to the PILOT position. Press in control knob for five (5) seconds.

Note: You may be running this heater for the first time after hook- ing up to gas supply. If so, the con- trol knob may need to be pressed in for 30 seconds. This will allow air to bleed from the gas system.

If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

6.With control knob pressed in, push down and release ignitor button. This will light pilot. The pilot is attached to the front of burner. If needed, keep pressing ignitor button until pilot lights.

PILOT

LO

OFF

 

HI

 

IGNITOR

Figure 19 - Control Knob for Thermostat Model CGS10P

Thermocouple

Ignitor Electrode

Pilot

 

 

Burner

Figure 20 - Pilot

Note: If pilot does not stay lit, refer to Troubleshooting, pages 14 through

16.Also contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 13.

7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

Note: If pilot goes out, repeat steps

3thru 7.

8.Turn control knob counterclockwise

Manual background to desired heating level. The main burner should light. Set control knob to any heat level between HI and LO (see Figure 19).

TO TURN OFF GAS TO

APPLIANCE

Shutting Off Heater

1.Turn control knob clockwise Manual background to the OFF position.

2.Turn off all electric power to the ap- pliance if service is to be performed.

Shutting Off Burner Only (pilot stays lit)

Turn control knob clockwise Manual background to the PILOT position.

THERMOSTAT

CONTROL

OPERATION

The thermostatic control used on this model differs from standard thermo- stats. Standard thermostats simply turn on and off the burner. The thermostat used on this heater senses the room tem- perature. At times the room may exceed the set temperature. If so, the burner will shut off. The burner will cycle back on when room temperature drops below the set temperature. The control knob can be set to any comfort level between 1 and 7.

Note: The thermostat sensing bulb mea- sures the temperature of air near the heater cabinet. This may not always agree with room temperature (depending on housing construction, installation loca- tion, room size, open air temperatures, etc.) Frequent use of your heater will let you determine your own comfort levels.

12

107295

Page 12
Image 12
Desa CGS10P, CG6P Thermostat Control Operation, Propane/Lp Gas Heater, Operating Heater, Continued, Lighting Instructions