D20H, D30H AND D44H MODELS PORTABLE FORCED AIR HEATERS

ASSEMBLY

These models are furnished with wheels and handles. Wheels, handles, and the mounting hardware are found in the shipping carton.

TOOLS NEEDED

Medium Phillips Screwdriver

3/8" Open or Adjustable Wrench

Hammer

1.

Slide axle through wheel support

 

frame. Install wheels on axle.

 

IMPORTANT: When installing wheels,

 

point extended hub of wheels toward

 

wheel support frame (see Figure 3).

2.

Place cap nuts on axle ends. Gently tap

 

with hammer to secure.

3.

Place heater on wheel support frame.

 

For D20H model, make sure outlet end

 

(front) of heater is over wheels. For

 

D30H and D44H models, make sure air

 

inlet end (rear) of heater is over wheels.

 

Line up holes on fuel tank flange with

D20H Model

Sleeve Cap

Screw

 

 

Hot Air

 

 

Outlet

Handle

 

 

 

Fuel

Air

 

Tank

 

Inlet

 

Flange

 

 

Axle

Cap Nut

Nut

Extended

Hub

 

Wheel

Front

HandleWheel Support

Frame

Screw

holes on wheel support frame.

4. For D20H model, place rear handle on

top of fuel tank flange. For D30H and

D44H models, place front handle and

rear handle on top of fuel tank flange.

Insert screws through handle(s), fuel

tank flange, and wheel support frame.

Attach nut finger tight after each screw

is inserted.

5. After all screws are inserted, tighten

nuts firmly.

Hot Air

Outlet

Fuel

Tank

Flange

Wheel

Support

Frame

WheelNut

Cap Nut

Rear

Handle

Air

Inlet

D30H and D44H Models

Extended

Axle Hub

VENTILATION

Figure 3 - Wheel and Handle Assembly

WARNING: Follow the mini- mum fresh, outside air ventilation requirements. If proper fresh, out- side air ventilation is not provided, carbon monoxide poisoning can occur. Provide proper fresh, out- side air ventilation before running heater.

Provide a fresh air opening of at least 2800 square cm (three square feet) for each 100,000 Btu/Hr rating. Provide extra fresh air if more heaters are being used.

Example: A 150,000 Btu/Hr heater requires one of the following:

a two-car garage door [4.9 m (16 ft.) open- ing] raised 9 cm (3.5 inches)

a single-car garage door [2.75 m (9 ft.) opening] raised 15.25 cm (6 inches)

two, 76 cm (30 inch) windows raised 28 cm (11 inches)

4

105843

Page 4
Image 4
Desa D30H, D44H, D20H owner manual Assembly, Ventilation, Tools Needed