Desa DCFTNA Installing Optional Blower Accessory GA3450TA, Reinstall top louver

INSTALLATION

Continued

9.Use two 3" wood screws provided and attach base of fireplace to wooden mantel base (see Figure 13).

10.Remove perimeter trim kit and mantel. Be careful not to damage wall or mantel.

11.Cut an access hole in base to run flexible gas line to fireplace (see Figure 13). Make sure to locate access hole so mantel will cover it when installed. Note: You can secure base to floor using wood screws. Countersink screw heads and putty over.

12.Install gas line. See Connecting To Gas Sup- ply, page 16.

13.Check for leaks. See Checking Gas Connec- tions, page 17.

14.Place mantel around fireplace. Be careful not to damage wall or mantel.

15.Place perimeter trim kit on the shoulder screws located on the side and top of the fireplace. Firmly snap trim over shoulder screws on fireplace (see Figure 13).

	Hole for
	3" Wood
	Screw for
	Attaching
Shoulder	Fireplace
Screw	to Mantel
Mantel
Base	Gas
	Line
	Access
	Hole

	Shoulder
	Screws
Assembled	Hole for 3" Wood Screw
Brass Trim	for Attaching Fireplace to
	Wooden Base

Figure 13 - Attaching Brass Trim to

Fireplace

16.Adjust assembly to remove any gaps. Attach remaining two 3" wood screws from hardware pack through openings inside of fireplace sides into the mantel. The openings are located at top behind the area for top louver (see Figure 13).

17.Reinstall top louver.

Assembling Perimeter Trim (Perimeter trim shipped with mantel)

1.Remove packaging from three remaining pieces of trim.

2.Locate two adjusting plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 14.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 14).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side perimeter trim (see Figure 14).

6.While firmly holding edges of perimeter trim together, tighten both set screws on the adjust- ing plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other corner.

8.Set perimeter trim assembly aside for later installation.

Set Screws
Adjusting
Plate		Top Brass
	Slot
		Trim
Shim		Mitered Edge
Side Brass
Trim
Figure 14 - Assembling Brass Trim

INSTALLING OPTIONAL BLOWER ACCESSORY GA3450TA

Removing Upper Louver To install the blower accessory, you must first remove the upper louver.

1.Lift screen off fireplace and remove log set if installed.

2.Remove 4 screws from upper louver (see Figure 12, page 12). Save these screws.

3.Pull upper louver straight out from the cabinet. Be careful not to scratch the paint. Set louver aside.

4.Open lower louver door by swinging door down (see Figure 12, page 12).

111244-01E www.desatech.com 13