Desa DCFTNA Optional Wireless HAND-HELD Remote Control Accessories, Optional Wall Mounted

INSTALLATION

Continued

OPTIONAL WIRELESS HAND-HELD

REMOTE CONTROL ACCESSORIES

Remote-Ready Models Only

([C]GHRCB Series & [C]GHRCTB

Series)

Installing Receiver

1.Disconnect wires from the control valve (see Figure 27) .

2.Locate the battery clip mounted on the back of the receiver (see Figure 28).

3.Slide 9-volt battery (not included) through the clip.

4.Attach the terminal wires to the battery (see Figure 28).

5.Connect wires from remote receiver to control valve as shown in Figure 29.

6.Install remote receiver unit onto remote/ blower bracket using screws provided (see Figure 29).

Figure 27 - Disconnecting Wires From

Control Valve

Receiver

9-Volt	Terminal
Battery	Wires
	Battery Clip

Figure 28 - Attaching Battery to Receiver

White Wire to

TH Terminal on

Control Valve

Remote

Receiver

Red Wire to

TPTH Terminal on

Control Valve

Figure 29 - Installing Remote Receiver

Installing 9-Volt Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to the battery (not includ- ed). Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

Terminal	Battery Cover		Remote
			Control Unit
Wires
9-Volt
Battery
		Battery
		Housing
Figure 30 - Installing Battery in Hand-
Held Remote Control Unit (GHRCB and
	CGHRCB Series)
Terminal Wires		Remote	Control Unit
9-Volt
Battery
			Battery
Battery			Cover
Housing
Figure 31 - Installing Battery in Hand-
Held Remote Control Unit (GHRCTB and
	CGHRCTB Series)
OPTIONAL WALL MOUNTED
THERMOSTAT - GWMT1
(Remote-Ready Models Only)
WARNING: Read and fol-
low installation instructions.
Installation should be done by
a qualified installer familiar with
low-voltage wiring procedures.
WARNING: Do not connect
this thermostat to any electrical
source! Electrical shock and/or
fire hazard will occur.

1.Remove jumper wire from control valve (see Figure 27).

111244-01E www.desatech.com 19