Illustrated Parts Breakdown | Desa DCFTNA manual

ILLUSTRATED PARTS BREAKDOWN

THERMOSTAT MODELS

FDCFTP, FDCFTN, VDCFTP, VDCFTN, CDCFTPA AND CDCFTNA

	4
	9
	2
1		3
		3
	6	5
	6
9		7
9

10

8

21
17	9
17

12

11

14 6

16 20

13

15

19

18

40

www.desatech.com

111244-01E

Image 40

Desa DCFTNA installation manual Illustrated Parts Breakdown

Contents

Shown with Optional Cabinet Mantel/Hearth Base Accessory What to do if YOU Smell GAS Table of Contents Safety Information Product Identification Provide adequate clearances around air openings Optional Remote Control Accessories Product FeaturesLocal Codes Unpacking Tools Required Phillips screwdriver Hood AssemblyHex wrench Scissors Providing Adequate Ventilation AIR for Combustion VentilationDetermining FRESH-AIR Flow for Fireplace Location Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Installation Check GAS Type Installation Items BUILT-IN Fireplace InstallationFireplace Clearances Minimum Clearance to Combustible Materials If you have not installed hood, follow instruc- tions on Depth Optional Mantel Installation Mantel Clearances for Built-In Installation Installing Optional Blower Accessory GA3450TA Reinstall top louverAlign shim under adjusting plate as shown in Figure Remove packaging from three remaining pieces of trim Installing Blower Accessory Door Test to make sure blower is working properly For Built-In InstallationLower louver Connecting to GAS Supply Sediment Trap Installation Items Needed Connecting Equipment Shutoff Valve to Heater ControlChecking GAS Connections Correct all leaks at once Els or page 25 for Remote-Ready Models Optional Wireless HAND-HELD Remote Control Accessories Installing ReceiverInstalling 9-Volt Battery in Hand-Held Remote Control Unit Optional Wall Mounted Optional Wall Switch GWMS2 Remote-Ready Models Only Remove jumper wire from control valve see , Installing LOG SET and Screen Models with One-Piece Screen Only Operating Fireplace Lighting Instructions Manual Lighting Procedure To Turn OFF GAS To ApplianceThermostat Control Operation Operating Blower REMOTE-READY Models For Your Safety Read Before Lighting AUTO/OFF/ON Blower Switch If Using Optional Hand-Held Remote Optional HAND-HELD Remote Operation Manual Mode Auto Thermostatic ModeAuto Shutoff Feature ON/OFF Series Model Cghrcb Optional GWMS2 Wall Mounted Switch Key Pad Lock FeatureInspecting Burners Optional GWMT1 Wall Mounted Thermostat Cleaning Maintenance Burner Flame PatternBurner Injector Holder and Pilot AIR Inlet Hole If burner ﬂame pattern is incorrect, as shown in Figure LOG SET Wiring DiagramCabinet Troubleshooting Observed Problem Possible Cause RemedyIgnitor cable pinched or wet Ignitor cable dry Burner oriﬁce is clogged Mote-Ready Models OnlyModels Only Or replace burner oriﬁce When heated, vapors from Walls or furniture Cleaners, etc. may turn intoMote-Ready Models Only Power is low Slight smoke or odor during Gas odor even when control Fireplace produces unwantedErs, chemicals, new carpet Ment above Thermostat Models SpecificationsRemote-Ready Models Replacement Parts Service HintsTechnical Service Parts Under Warranty Illustrated Parts Breakdown Parts List Illustrated Models Firebox Models CDCFNR, Cdcfpr Illustrated Parts Breakdown Thermostat Models FDCFTN/TP, VDCFRN/RP CDCFNR/PR REMOTE-READY Models Accessories Equipment Shutoff Valve GA5010Brass Trim KIT GA6095 THERMOSTAT-CONTROLLED Blower KIT GA3450TA WALL-MOUNT Thermostat Switch GWMT1 WALL-MOUNT ON/OFF Switch GWMS2Cleaning KIT GCK/CCK Receiver and HAND-HELD Remote Control KIT Ghrcb and Cghrcb 111244-01E 111244-01E Not a UPC