NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

¢￿ WICK ASSEMBLY- Check at least once a month!!

The burner assembly sits on top of the wick guide. Over time, tar deposits can accumulate on the wick guide, and this can prevent the burner assemby from seating properly. This can result in poor combustion, smoke, odor, etc.. To prevent this from happening, tar deposits on the wick guide can be removed as follows:

¡'Making sure that the heater is both cool and turned off, lower the wick to the "off" position. ¡'Remove the batteries (located at the rear of the heater).

¡'Remove the 2 cabinet screws. Lift off the cabinet and grille assembly as shown in illustration (Fig. A).

¡'Using the wick adjuster knob, raise the top of the wick until it is even with the top of the wick guide. Using a flat-edge screwdriver, scrape off the tar deposits.

Be careful not to allow any of the tar deposits to drop into the grooves of the wick guide. A small vacuum cleaner can be used to remove the tar deposits that have been scraped off (Fig. B).

¡'Reassemble the heater and replace the batteries.

¢æ WICK REPLACEMENT

Fig.A

Fig.B

The wick in your heater needs replacing if, after repeated cleanings, any of the following conditions still exist: slow to light, hard movement of the wick adjuster knob, kerosene odor while burning, low heat output, slow warm up, damaged wick.

Use only a genuine replacement wick.

REPLACEMENT WICK NUMBER: Kero-World 32225, Dura Heat DH-145, Glowick 30856.

If cleaning the Wick does not improve performance, you will need to replace the Wick Refer to the "TROUBLE SHOOTING GUIDE", see page 14. which outlines conditions under which the Wick should be replaced.

CAUTION : Use ONLY a genuine Replacement Wick. Part Number : Kero - World 32225, Dura Heat DH-145,Pick-A-WickPW-72. DO NOT attempt to substitute any other type of Wick device or a Wick designed for another brand or model heater You could damage the heater and create a potential fire hazard.

Call customer service at 1-800-668-5323, to order wick.

ATTENTION : The only tools needed to replace the Wick are :

 

A Pair of Pliers

A Flat blade Screwdriver

A Plastic Bag with a Twist Tie

1. Push down the manual shut-off knob and turn the Wick Adjustment Knob COUNTERCLOCKWISE in the direction of "OFF".

2. Use Pliers to loosen and remove cabinet screws on either side of the Heater Cabinet.

3. Use the Carrying Handle to lift the Cabinet straight up and away from the heater.

4. Gently pull the Wick Adjustment Knob off the heater.

5. Remove the Cabinet Base

by lifting it from the back and

tilting it forward to clear the

Wick Adjuster Assembly.

6. Trip the Pendulum on the Automatic Safety Shutoff System to activate it.

9

Page 10
Image 10
Desa DH2304 owner manual ¢ Wick ASSEMBLY- Check at least once a month