Product Identification
Control |
| Remote Hide | Flame Control |
| Ember Control | ||
Panel |
|
| Backlight |
Door |
|
| |
|
| Control | |
|
|
| |
Heat Vents |
|
|
|
(Behind Door) |
|
|
|
Front Glass |
| Flame Ember | Backlight |
|
|
| Power |
|
| Heater | Magnetic |
|
| Control | |
|
| Catch | |
|
|
| |
|
| ON/OFF | |
|
| Power | |
| Log Set | Button | |
|
|
| |
Figure 2 - Product Identification
Unpacking and Testing
Carefully remove unit from box. Prior to permanently installing unit, test to make sure unit operates properly. Unit does not come with a power cord installed. Unit must be hard wired to either a 120/60 or 240/60 volt supply.
CAUTION; The unit must be connected to a properly groundedandprotected120/240 volt circuits.Always use ground fault protection where required by the electrical code.
WARNING: Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is damaged, return the unit to an authorized service facility for examination, electrical or mechanical adjustment or repair.
Locating Fireplace
WARNING: Due to high tem- peratures, this heater should be located out of traffic. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from the front of the heater.
WARNING: Never locate this heaterwhereitmayfallintoabathtub or other water container.
NOTICE:Minimumandmaximum clearancesmustbemaintainedat alltimes.Illustrationsthroughout these instructions reflect typical installations and are for design purposes only. Actual installations may vary slightly due to individual preferences.
WARNING: To prevent contact with sagging or loose insulation, the heater must not beinstalledagainstvaporbarrier orexposedinsulation.Localized overheating could occur and a fire could result.
4 | www.desatech.com |