Accessory Installation

Continued

Removing Bifold Glass Doors

Bifold doors may be removed for replacing or cleaning.

1.Partially open each door and press up on upper spring clip with a screw driver until outer top pivot pin is free of the clip.

2.Fully fold frame assembly and slide upper edge towards center of firebox opening until the guide pins are free of the frame rail (see Figure 11, page 8).

Cleaning

WARNING: Always disconnect power and allow the heater to cool before performing any cleaning,maintenanceorrelocation of this heater. Turn controls to OFF and remove plug from outlet or turn off circuit breaker to heater.

Cleaning Firebox

1.Open bi-fold doors and screens.

2.Using a brush vacuum attachment, gently clean compartment.

3.Close screens and doors.

Cleaning back screen (Glass)

1.The glass is cleaned in the factory during assembly. During shipment, installation, handling, etc. glass surface may collect dust particles. These can be removed by buffing lightly with a clean damp cloth

(water only). Glass should be completely dried with a lint free cloth or paper towel.

2.To access glass to clean, follow steps 1 through 5 under Service Preparation, page 10.

3.Using gloves, gently remove glass panel by sliding it toward you. There is a rubber bumper on each corner of glass.

4.Clean glass as instructed in step 1.

5.Follow steps 8 through 13 under Service Preparation, page 10.

Servicing

WARNING:Turnoffappliance and let cool before servicing. Only a qualified service person should service and repair heater.

For questions regarding replacing parts, see page 13.

Note: All service procedures are performed through front face opening of fireplace.

Replacing log

1.Turn off power to unit (circuit breaker).

2.Open upper control panel door. Turn power switch off.

3.Open bi-fold doors (if equipped) and screens.

4.Remove screws securing each side of log to brackets (see Figure 13).

5.Carefully remove old log.

6.Install new log.

7.Reinstall screws into brackets to secure new log.

8.Close screens and doors.

Screw

Log

Ember LED Strip

 

 

with Standoffs

Figure 13 - Removing Log and Ember LED

122663-01D

www.desatech.com

9