Opening Vent Damper, Door | Desa VM36E, VM42E instruction

INSTALLATION

Installing Optional Glass Door Accessory (Cont.) Opening Vent Damper

INSTALLATION

Continued

5.Once the top and bottom pins are secured, unfold the door into the closed position.

6.Repeat the process for the opposite door assembly.

7.To adjust the doors, slide them partially open. Using a screw- driver, loosen the hold-down screws in the spring clip (see Fig- ure 34) and pivot plate.

8.Close both doors until evenly joined at the middle and note the gap at the outer edges of the face.

9.Reopen one door at a time and retighten the upper and lower hold-down screws.

10.Repeat the process until both doors are evenly joined, spaced and working freely.

CAUTION: The glass panels become very hot while the appliance is operating. Do not attempt to adjust or clean the glass doors until the appliance has fully cooled.

The doors may be removed for replacement or cleaning as follows:

1.Partially open the door and press up on the upper spring clip with a screw driver until the outer top pivot pin is free of the clip.

2.Fully fold the frame assembly and slide the upper edge to- wards the center of the firebox opening until the guide pins are free of the frame rail (see Figure 35).

CAUTION: Always operate the appliance with the doors either fully opened or fully closed. Operating the appliance with the doors partially open can result in improper venting of flue products.

	Spring Clip
	Depress Spring
	Clip to Release
	Pivot Pin
Fold Bi-Fold
Door After
Releasing	Remove
Spring Clip and	Bottom Pin
Slide Door Out	From Pivot
of Upper Track	Plate While
	Sliding Door
	Out of the
	Upper Track
	Pivot Plate
Figure 35 - Removing Glass Doors