Desa NATURAL GAS LOG HEATER Optional, Positioning, Sensing Bulb, Of Thermostat, For Masonry and

OPTIONAL	If your log set cycles to pilot, but the room temperature drops to a lower than
	ideal comfort level before the log set comes back on, you may want to reposi-
POSITIONING
	tion the thermostat sensing bulb.
OF THERMOSTAT	The thermostat sensing bulb is located on the gas valve assembly. This location allows the
SENSING BULB	thermostat to keep the room temperature at an ideal comfort level for most fireplace
	applications. For positioning the thermostat sensing bulb elsewhere, an adhesive-backed
For Masonry and	mounting clip has been provided.
	Tools needed: 5/16" hex driver or socket
Factory-built
	1. Locate the gas valve assembly and thermostat sensing blub (see Figure 28).
Metal Fireplace

Gas Valve

Assembly

Thermostat

Sensing Bulb

Figure 28 - Location of Gas Valve Assembly and Thermostat Sensing Bulb

2.The adhesive-backed mounting clip (see Figure 29) is attached to the thermostat sensing bulb. Remove the adhesive-backed mounting clip.

Figure 29 - Adhesive-backed Mounting Clip

3.With 5/16" hex driver or socket, loosen the thermostat screw. Carefully slide the thermo- stat sensing bulb out of the retaining clamp (see Figure 30).

Note: Do not remove the screw. Make sure you tighten the screw after removing the thermostat sensing bulb.

IMPORTANT: Do not force or bend the thermostat sensing bulb or capillary.

Capillary

Thermostat Sensing Bulb

Screw

Retaining Clamp

Figure 30 - Removing Thermostat Sensing Bulb
4. The thermostat sensing bulb may be located to the lower right front side of fireplace.
Determine location of sensing bulb, but do not mount sensing bulb until step 5. If you
have a masonry fireplace, see Figure 31 for location.	29

101308