Desa NTH35, NTH150, NTH50, NTH100 Assembly, Ventilation, FOR 100,000 AND 150,000 BTU/HR MODELS ONLY

PORTABLE FORCED AIR HEATERS

ASSEMBLY	2. Place cap nuts on axle ends. Gently tap
	with hammer to secure.

VENTILATION

(FOR 100,000 AND 150,000 BTU/HR MODELS ONLY)

These models are furnished with wheels and handles. Wheels, handles, and the mounting hardware are found in the shipping carton.

Tools Needed

•Medium Phillips Screwdriver

•3/8" Open or Adjustable Wrench

•Hammer

1.Slide axle through wheel support frame. Install wheels on axle.

IMPORTANT: When installing wheels, point extended hub of wheels toward wheel support frame (see Figure 3).

3.Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Line up holes on fuel tank flange with holes on wheel sup- port frame.

4.Place front handle and rear handle on top of fuel tank flange. Insert screws through handles, fuel tank flange, and wheel support frame. Attach nut finger tight after each screw is inserted.

5.After all screws are inserted, tighten nuts firmly.

WARNING: Follow the mini- mum fresh, outside air ventilation requirements. If proper fresh, out- side air ventilation is not provided, carbon monoxide poisoning can occur. Provide proper fresh, out- side air ventilation before running heater.

Provide a fresh air opening of at least 2800 square cm (three square feet) for each 100,000 Btu/Hr rating. Provide extra fresh air if more heaters are being used.

Example: A 150,000 Btu/Hr heater requires one of the following:

• a two-car garage door (16 feet wide open-
	ing) raised 9 cm (3 1/2 inches)
•	a single-car garage door (9 feet wide
	opening) raised 15.25 cm (6 inches)
•	two, 76 cm (30 inch) windows raised 31

Screw

Hot Air

Outlet

Fuel Tank

Flange

Wheel

Support

Frame

WheelNut

Cap Nut

Front Handle

Rear

Handle

Air

Inlet

Extended

Axle Hub

cm (12 inches)

Figure 3 - Wheel and Handle Assembly, 100/150,000 Btu/Hr Models Only

4 104976