![](/images/new-backgrounds/1059052/5905211x1.webp)
INSTALLATION
Continued
CAUTION: This heater cre- ates warm air currents. These currents move heat to wall sur- faces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities (such as, but not limited to, tobacco smoke, aromatic candles, cleaning flu- ids, oil or kerosene lamps, etc.) in the air exist, may discolor walls or cause odors.
CAUTION: If you install the heater in a home garage
•heater pilot and burner must be at least 18" above floor.
•locate heater where moving vehicle will not hit it.
For convenience and efficiency, install heater
•where there is easy access for operation, inspec- tion and service
•in coldest part of room
CEILING
36" Minimum
6"
Minimum
From Sides Of
Heater
| Right |
Left | Side |
Side | Minimum To |
| Top Surface |
| Of Carpeting, |
| 3" Tile Or Other |
FLOOR | Combustible |
Material |
Figure 2 - Mounting Clearances As
Viewed From Front of Heater
THERMOSTAT SENSING BULB
The thermostat sensing bulb is located inside the heater. Do not move this bulb during installation or operation of the heater.
INSTALLING HEATER TO WALL
Marking Screw Locations
1. Determine where you will locate heater.
WARNING: Maintain mini- mumclearancesshowninFigure
3.If you can, provide greater clearances from floor and join- ing wall.
2.Mark two mounting screw locations on wall (see Figure 3).
Installing Two Mounting Screws
Note: Wall anchors and mounting screws are in hardware package. The hardware package is provided with heater.
|
| 8 7/8" |
|
|
| 7 3/4" |
|
|
|
|
|
| |
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
| ||||
| Minimum To |
|
|
|
|
|
|
|
|
| |||
| Maintain 6" |
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| |||||
| Clearance |
|
|
|
|
|
|
|
|
| |||
| From Wall |
|
|
|
|
|
|
|
|
| |||
WALL | Mounting | 20 | 1 | / " | |||||||||
|
|
|
|
|
|
|
|
|
| 4 | |||
JOINING |
| Screw | Minimum To | ||||||||||
Locations | Maintain 3" | ||||||||||||
|
|
|
|
Clearance
From Floor
FLOOR
Figure 3 - Mounting Screw Locations
Attaching To Wall Stud Method
For attaching mounting screw to wall stud
1.Drill hole at marked location using 9/64" drill bit.
2.Insert mounting screw into wall stud.
3.Tighten screw until 1/16" space (thickness of penny) is between screwhead and wall.
Attaching To Wall Anchor Method
Follow instructions below to attach mounting screws to hollow walls (wall areas between studs) or solid walls (concrete or masonry).
1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1 1/4" deep.
2.Fold wall anchor (see Figure 4, page 7).
6 | www.desatech.com |