OPERATING HEATER
21
OPERATING HEATER
Continued
OPTIONAL REMOTE OPERATION
Note: All remote control accessories must be purchased sepa- rately (see Accessories, page 34). Follow instructions included with the remote control.
Thermostat Control Operation
(Optional GHRCTA Series Only) The thermostat control set- ting on the remote control unit can be set to any comfort level between WARMER and COOLER. The burners will turn on and off automatically to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central heating system, etc.
For wall thermostat operation, follow instruction supplied with thermostat accessory GWMT1. For wall switch operation follow instructions supplied with GWMS2.
NOTICE: You must light the pilot before using the
1. After lighting, let pilot flame burn for about one minute. |
Turn control knob to ON position. Adjust flame adjust- |
ment knob anywhere between HI and LO. Slide the selec- |
tor switch to the REMOTE position. Note: The burners |
may light if |
lector switch was last turned off. You can now turn the burn- |
ers on and off with the |
IMPORTANT: Do not leave the selector switch in the RE- |
MOTE position when the pilot is not lit. This will drain the |
battery. |
IMPORTANT: Be sure to press the ON/OFF buttons on the |
•In the AUTO mode, the thermostat in the
IMPORTANT: This remote control has been specially en- gineered to take an air temperature sample every 5.5 min- utes in the auto mode. It will not respond immediately to the temperature setting being turned up or down.
IMPORTANT: The
3.To turn the burner off, press the AUTO/ON/OFF button un- til OFF lights. The pilot will remain lit.
IMPORTANT: To turn the pilot off, manually turn the con- trol knob on the heater to the OFF position.
Control Knob
Rear Burner
Control Knob
| OT | O |
| IL | |
| P | N |
| F |
|
ON OFF REMOTE | F |
|
O |
| |
|
|
Selector | Ignitor Button |
| |
Switch |
|
Figure 35 - Control Knobs, Selector Switch and Ignitor Button Locations for Remote Operation
proper operation. |
GHRC Series Operation:
2a. Press the ON/OFF button to turn the burners on and off. When turning burners off, the pilot will remain lit.
GHRCTA Series Operation:
2b. Press the AUTO/ON/OFF button on the
•In the ON mode, the burners will ignite. The heater is in manual mode when ON is lit.
Shows
Temperature
Setting
The Log Heater will Automatically Cycle between Pilot and the Heat Setting that has been Selected
Increases Room
Temperature in
AUTO Mode
Decreases Room
Temperature in
AUTO Mode
Turns Burners
On or Off and
Allows You to
Choose the Auto
Setting
Figure 36 - Thermostat
Selections (GHRCTA Only)
For morevisit www..com