Desa RLP100 Service Procedures, Continued, Removing Ignitor Mounting, Screw and Ignitor

SERVICE PROCEDURES

Continued

IGNITOR

1.Remove motor, motor mount and fan guard (see Motor, page 8, steps 1 through 6) .

2.Remove orange ignitor wire from ignitor.

3.Remove ignitor mounting screw from rear head using nut-driver or standard screwdriver (see Figure 11).

4.Remove ignitor from rear head.

5.Install new ignitor. Attach ignitor to rear head with ignitor mounting screw.

6.Attach ignitor wire.

7.Check gap between ignitor electrode and nozzle to .13"/.15" (3.3/3.8 mm) (see Fig- ure 12).

8.Test for spark.

WARNING: Make sure heater is disconnected from propane supply. Heater could ignite caus- ing severe burns.

Plug into extension cord and watch for spark between ignitor electrode and nozzle.

9.Place motor, motor mount and fan guard into rear of heater shell (see Motor, page 8, steps 14 through 18).

	Ignitor
Ignitor
Mounting	Rear
Screw	Head

Figure 11 - Removing Ignitor Mounting

Screw and Ignitor

Burner

Nozzle

Ignitor

Electrode

Gap

Area

Figure 12 - Clearance between Ignitor Electrode and Target Plate

10 www.desatech.com 111710-01B