VENT-FREE NATURAL GAS PEDESTAL STOVE
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION:Afterinstallationand periodically thereafter, check to en- surethatnoflamecomesincontact with any log. With the heater set to High, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation in- structions in this manual. Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Place
IMPORTANT: Make sure log does not cover any burner ports (see Figure 10).
One Piece
Log Set
INSTALLING BLOWER ACCESSORY - GA3750
Tools required: Phillips screwdriver
NOTICE: Shut off gas heater during the following blower installation.
1.Remove top panel of stove by remov- ing three screws from under top lip on each side of stove (see Figure 11).
2.Facing front of stove, carefully slide top panel forward until it is completely re- moved from stove (see Figure 11).
3.Disconnect power cord wires from blower motor (if connected) (see Figure 12).
4.Disconnect green ground wire from blower housing (if connected) by re- moving screw holding wire terminal (see Figure 12).
Figure 11 - Removing Stove Top Panel
White Powercord Wire
Black Powercord Wire
5.Install one plastic bushing provided in blower kit into the 1 1/2" hole in the left rear of firebox floor. Access hole through the rectangular opening in the rear panel (see Figure 13).
6.Remove the two blower mounting brackets from the rear panel by remov- ing two screws each (see Figure 14).
7.Attach the two mounting brackets to blower housing using four screws pro- vided in blower kit (2 for each bracket) (see Figure 14). Tighten screws se- curely. Place blower assembly tempo- rarily on top of firebox.
8.Working from the rear of the stove, place entire power cord, including speed control housing, in lower control compartment.
9.Route ends of
10.Attach the terminal ends of the white and black power cord wires to the ter- minals on the blower motor (see Fig- ure 14). Push firmly.
11.Attach the terminal end of the green power cord wire to the front tab of the blower housing using screw provided (see Figure 12).
12.Using the four screws previously re- moved, mount blower assembly to stove by reattaching blower brackets to rear panel (see Figure 14). Tighten screws securely.
Blower
Bracket
Firebox Floor
Figure 9 - Installing One-Piece Log Set
Burner Ports | One Piece Log Set |
Figure 10 - Installing One-Piece Log set (Top View)
Screw |
|
Green | Blower |
Ground Wire |
|
Figure 12 - Removing Wires from Blower
Figure 13 - Installing Bushing
Firebox Top
Figure 14 - Removing Blower Brackets from Stove and Attaching to Blower
For more information, visit www.desatech.com | 10 | 105683 |
