HIGH PRESSURE PORTABLE FORCED AIR HEATER 350,000 AND 600,000 BTU/HR
SERVICE PROCEDURES
WARNING: Never service heater while it is plugged in, op- erating, or hot. Severe burns and electrical shock can occur. Only a qualified service person should service and repair heater.
Fan Blades and Air Deflectors
1.Remove upper shell (see column 1).
2.Clean fan blades and air deflectors with clean, soft cloth moistened with kero- sene or solvent (see Figure 6).
3.Dry fan blades and air deflectors thor- oughly.
4.Replace upper shell.
Air Deflector
Nozzle
1. | Remove upper shell (see column 1). |
2. | Remove fuel line from solenoid valve |
| using 7/16" wrench. |
3. | Remove spark plug wire from spark |
| plug. |
4. | Remove spark plug from burner head |
| using 13/16" |
5. | Remove five screws using |
| 5/16" |
Upper Shell Removal
1.Remove screws along each side and top of heater using 5/16"
2.Lift upper shell off.
| head from combustion chamber. |
6. | Place burner head into vise and lightly |
| tighten. |
7. | Carefully remove nozzle from burner |
| head using 5/8" socket wrench (see Fig- |
| ure 9). |
8. | Inspect nozzle for damage. If damaged |
| or clogged, replace nozzle. |
9. | Make sure plug is in place on burner |
Upper Shell
Figure 5 - Upper Shell Removal, 600,000 Btu/Hr Model
Fan Blade
Figure 6 - Fan Blades and Air Deflectors
Spark Plug
1.Remove upper shell (see column 1).
2.Remove spark plug wire from spark plug (see Figure 7).
3.Remove spark plug from burner head using 13/16"
4.Replace spark plug if damaged or heavily coated with carbon.
5.Clean and regap spark plug electrodes to .075 inch (see Figure 8).
6.Install spark plug in burner head.
7.Attach spark plug wire to spark plug.
8.Replace upper shell.
Burner Head
Spark Plug
Spark
Plug Wire
Figure 7 - Spark Plug Removal
.075 inch
Figure 8 - Spark Plug Gap
| head. |
10. | Replace nozzle into burner head and |
| tighten firmly |
11. Attach burner head to combustion | |
| chamber. |
12. | Install spark plug in burner head. |
13. | Attach spark plug wire to spark plug. |
14. | Attach fuel line to solenoid valve. |
| Tighten firmly. |
15. | Replace upper shell. |
Nozzle
Plug Spark
Plug
|
| Spark |
Burner |
| Plug |
| Wire | |
Head |
| |
| Solenoid | |
| Fuel | |
| Valve | |
| Line | |
|
|
Figure 9 - Replacing Nozzle
10 | 106029 |