Desa SL-5512 Test And Adjustment, Specifications, Maximum Range, MotionMotion, Least Sensitive

Aim Sensor

Higher for Long

Coverage

TEST AND ADJUSTMENT

❒Turn on the circuit breaker and light switch.

NOTE: Sensor has a 1 1/2 minute warm up period be- fore it will detect motion. When first turned on or when switching modes wait 1 1/2 minutes.

❒Turn the RANGE control to the mid position, Dual Brite™ to OFF and the ON-TIME control to the TEST position.

MAX
B	O	ON - TIME	DUAL BRITE
	O
	S
MIN	T
	TEST 1 5 2 0		OFF 3 6	DUSK TO
RANGE
		MINUTES	HOUR	DAWN

Bottom of Sensor

Avoid aiming the sensor at:

•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor.

	240°
8 ft.
(2.4 m)
70 ft.	100 ft.
(21 m)	(30.5 m)
	Boosted

Maximum Range	Maximum
	Coverage Angle

The detector is less sensitive to motion directly towards it.

MotionMotion

Least Sensitive Sensor Most Sensitive

❒ Loosen the clamp screw in the	Clamp
sensor ball joint and gently	Screw
rotate the sensor.
❒ Walk through the coverage	Ball
area noting where you are
	Joint
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cover-
age area.Keep the sensor at
least 1" (2.5 cm) away from	Aim Sensor
the lamps.
	Down for Short
❒ Adjust the RANGE as needed.
	Coverage
RANGE set too high may
increase false triggering.

❒ Secure the sensor head's aim by tightening the clamp screw. Do not overtighten the

screw.

❒ Set the amount of TIME you want the lights to stay on after

motion is detected (1, 5, or 20 minutes).

❒Set the DUAL BRITE™ switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs., Dusk-to-Dawn).

SPECIFICATIONS

Range . . . . . . . . . . . . Up to 70 ft. (21 m); 100 ft. (30.5 m) with Range Boost. [varies with surrounding temperature]

Sensing Angle . . . . . . Up to 240°

Electrical Load. . . . . . Up to 300Watt Maximum Incan- descent [Up to 150 Maximum each lamp holder].

Power Requirements . 120 VAC, 60 Hz

Operating Modes . . . . TEST, AUTO and MANUAL

MODE

Time Delay . . . . . . . . 1 , 5, 20 minutes Replacement lamp. . . T3, 150W halogen maximum

120 VAC

Dual Brite™ Timer . . . Off, 3, 6 hours, Dusk-to-Dawn

DESA Specialty Products™ reserves the right to dis- continue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

595-5575-06 3