Desa SMA24VNA, SMA18VPA, SBJ24VNA, SBJ18VPA installation manual CAUTION Do not try to ad

OPERATING HEATER

		Continued
	CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
		WARNING: Make sure the
selector switch is in the OFF
position when you are away
from home for long periods
of time. Heater will come on
automatically with					selector
switch in the ON position.
Pilot		Ignitor		Ignitor Electrode
		Electrode
Burner
			Pilot
			Burner
Propane/LP					Natural
		Figure 19 - Pilot
		TO TURN OFF GAS
		TO APPLIANCE
Shutting Off Heater

1.Turn control knob clockwise to the OFF position.

2a.	Set switch in the OFF position.
2b.	If Using Optional Hand-Held Remote:
	Set selector switch in the OFF position to
	prevent draining battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot
lit by doing one of the following:

1.Turn control knob clockwise to the PILOT position.

2.Use remote control manual OFF button.

3.Set selector switch in the OFF position.

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, page 17.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, Lighting Instructions, page 17.

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page

27). Follow instructions included with the remote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 17.

After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Flip AUTO/OFF/ON switch to AUTO. Slide the selector switch to the REMOTE position (see Figure 20). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

		Selector Switch in
Control Knob		REMOTE Position
		REMOTE
		OFF
		ON
Piezo	Flame
	Adjustment
Ignitor
	Knob

Figure 20 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

ON/OFF SERIES (MODEL GHRCB)

Hold the control button on the hand-held re- mote until burner turns on. Hold the control button again until burner turns off (see Figure 21, page 19).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand- held remote control until the light stops flashing. The hand-held remote is now unlocked.

18 www.desatech.com 114744-01B