Installing Logs, Will create soot

OWNER’S MANUAL

INSTALLATIONS

Continued

INSTALLING LOGS

CAUTION: Do not remove the warning and instruction labels attached to the heater base as- sembly. These markings contain important warranty information.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

One Piece

Log Set

Middle

Section at

Bottom of

Log Set

Burner

"U"-shaped

ChassisCutout in Chassis

Figure 23 - Installing One Piece Log Set

WARNING: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flame contact any log. If so, repo- sition logs according to the log installation instructions in this manual. Flames contacting logs

Burner Ports

One Piece Log Set

will create soot.

It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place one-piece log set on grate to fit as illustrated in Figure 24. Make sure middle section at bottom of log set is seated into "U"-shaped cutout in cen- ter of chassis (see Figure 23).

IMPORTANT: Make sure log does not cover any burner ports.

2.Install front window assembly to front of fireplace by slipping bottom window tabs into rectangular notches on fire- place front (see Figure 25). Then insert and tighten two screws through the top corners of the window assembly and fireplace front.

WARNING: You must operate this fireplace with the front win- dow assembly in place. Make sure front window assembly is in place before running fireplace.

Figure 24 - Installing One Piece Log Set

(Top View)

Screw

Window Tabs

Front Window

Assembly

Figure 25 - Installing Fireplace Front Window Assembly

Front Window Assembly

Notches