Desa VCGF30NR Product Identification, Local Codes, Unpacking, Remote Control Accessories

OWNER’S MANUAL

PRODUCT

IDENTIFICATION

One Piece Log Set

Optional

Remote

Control

I

H

L

OF
NO	F
T O	P

LOCAL CODES

Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANS Z223.1, also known as NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

UNPACKING

CAUTION: Do not remove the metal data plates from the heater

Control

Knobs

Piezo

Ignitor

Selector Switch (Optional)

base assembly. The data plates contain important product information.

Figure 1 - Log Base Assembly

Top Louver

Assembly

Firebox

Hood

Firebox

Support

Front

Window

Assembly

Figure 2 - Fireplace	Bottom Louver
	Assembly

Top Outer

Casing

Catalytic

Filter

(Mounted To

Inside

Firebox Top)

Blower Assembly (Optional)

1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.

2.Locate two phillips-head screws at top corners of front window assembly. Re- move and save these screws. Carefully lift front window assembly up and out from fireplace front.

3.Remove protective packaging applied to logs, log base assembly, and fireplace.

4.Remove fireplace hood from carton insert.

5.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought fireplace.

REMOTE CONTROL ACCESSORIES

There are four optional remote controls that can be purchased separately for this log heater:

•wall switch

•wall thermostat

•hand-held ON/OFF remote

•hand-held thermostat remote

See Accessories, pages 22 and 23.

104636 3