Desa VGL24PRA Continued, Optional Hand-Held Remote Operation, Thermostat Series Model, Ghrctb

OPERATING HEATER

Continued

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, pages 29). Follow instructions included with the re- mote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 19.

After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 30). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

TO LOCK press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed. TO UNLOCK press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

THERMOSTAT SERIES (MODEL
GHRCTB)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 32). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Digital	Turns Hand-
Display	Held Remote
Shows	On or Off and
Temperature	Allows You
and Settings	to Choose
	the Manual
Turns	Setting
Burners On
or Off	Selects Auto
	Setting

Flame Adjustment

Control Knob in Knob

On Position

	F	PIL
		OT	H
O	F
		O	I	O	REMOTE	OFF	ON
		N
				L

Selector Switch in Remote Position

Decreases
Room
Temperature
in AUTO
Mode	Locks System to
	Prevent Accidental
	Ignition

Increases

Room

Temperature

in AUTO

Mode

Figure 30 - Setting the Selector Switch,

Control Knob, and Flame Adjustment

Knob for Remote Operation

ON/OFF SERIES (MODEL GHRCB)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 31).

Control Button

Turns Burners

On and Off

Figure 31 - On/Off Hand-Held Remote Control Unit (GHRCB)

Figure 32 - Thermostat Hand-Held Remote Control Unit (GHRCTB)

Manual Mode

1.Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2.Press the MANU button to turn on the fireplace.

3.Press the POWER and LOCK buttons together to turn off the fireplace.

Auto (Thermostatic) Mode

1.Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2.Press AUTO button to select this mode.

3.Set the desired room temperature by press- ing the TEMP + or - buttons.

112882-01B www.desatech.com 21