Desa VGL24PRA, VGL24NRA, VGL18PRA, VGL30NRA installation manual Continued, Connecting Wires

INSTALLATION

Continued

8.Install remote receiver into receiver bracket using pads and push button clips provided with receiver (see Figure 20).

9.Connect wires to control valve at the TPTH and TH locations as shown in Figure 21. Note: Make sure excess wire does not interfere with burner or pilot.

10.If heater was removed from fireplace before installation of remote accessory, see Installing Heater Base Assembly on page 13 to reinstall heater into fireplace. Test gas connection for leaks (see Checking Gas Connections, pages 15 and 16).

11.If logs were removed from heater for install remote accessory, replace logs (see Installing Logs, pages 18 and 19).

9-Volt Battery

Battery

Clip

Bracket	Pad	Terminal
Push Button
		Wires
Clips
Figure 20 - Installing Remote Receiver

White Wire

From Receiver

Control

Valve

Red Wire From

Receiver

Figure 21 - Connecting Wires

Installing Batteries for Remote Receiver and Hand Held Remote Control Two 9-volt alkaline batteries (not included) are required to operate this heater with the wireless hand-held remote control set. One battery must be installed in the receiver and one in the hand- held remote control unit. Note: Only use alkaline batteries.

Installing 9-Volt Battery in Receiver

1.Locate back of receiver behind receiver bracket mounted on base assembly.

2.Locate the battery clip mounted on the back of the receiver (see Figure 20).

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Installing 9-Volt Battery (Not Included) in Hand- Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to the battery. Place battery into the battery housing.

Terminal	Battery Cover
Wires

			Remote
			Control
9-Volt		Battery	Unit
Battery
		Housing
Figure 22 - Installing Battery in Hand-
Held Remote Control Unit (CGHRCB
	Series)
		Remote
	Terminal	Control Unit
9-Volt	Wires
Battery
			Battery
Battery			Cover
Housing
Figure 23 - Installing Battery in Hand-
Held Remote Control Unit (CGHRCTB
	Series)

112882-01B www.desatech.com 17