GLASS DOOR
INSTALLATION
IMPORTANT: Install glass door frame first before installing glass door.
DOOR FRAME ASSEMBLY
Inset
Flat Head Screw
Top
Bottom
Figure 24 - Assembling Door Frame
INSTALLING DOOR FRAME
To install glass door frame, construct an opening (see table) on the front face of the fireplace. Insert door frame into face opening and tighten screws (see Figure 25).
MODEL | A | B |
JM50 | 51" +/- 1/4" | 34" +/- 1/4" |
JM42 | 43" +/- 1/4" | 34" +/- 1/4" |
JM36 | 37" +/- 1/4" | 34" +/- 1/4" |
A
3/4" Cap Screw
Top and Bottom
B
INSTALLING GLASS DOORS
Spring clips have been installed but some adjust- ments may be needed. Install the doors using the following steps:
1.With
2.Repeat step 1 for remaining door.
If you find the doors do not close properly or do | |
not appear level or straight, proceed with section | |
on door adjustment, |
|
Fold Door | Spring |
and Slide | Clip |
Top pins | Insert Pin |
Into Track | |
| into Spring |
| Clip |
| Insert |
| Bottom |
| Pivot Pin |
| into Hole |
| Pivot |
| Hole |
Figure 26 - Installing | |
DOOR ADJUSTMENT |
|
Remove doors and slightly loosen lower pivot clips | |
and upper spring clips. Replace doors and fully | |
close them. Use 1/8" shims (any material) to level | |
doors. Once proper setting is achieved, carefully | |
open doors enough so that you can access spring | |
clips with a phillips screwdriver. Tighten screws. | |
See Figure 27. |
|
1" Cap Screw
Left and Right
Figure 25 - Installing Door Frame
Figure 27 - Adjusting Bi-Fold Doors
20 | www.desatech.com |