VENTING INSTALLATION
Continued
4.Remove the shingles around the opening measured. Cut out this section.
5.Add the next sections of the pipe until the end penetrates the roof line. Check to see that the proper clearances are maintained. Extend chimney by adding sections of double wall pipe until pipe is minimum of 30" above the highest point of the roof cutout. Termination and chimney must extend a minimum of 36" above the highest point where it passes through the roof.
FLASHING INSTALLATION (V6F-10DM OR V12F-10DM)
Determine the flashing to be used with the roof opening chart. Slide flashing over pipe until base is flat against roof. Replace as many shingles as needed to cover exposed area and flashing base. Secure in position by nailing through shingles (see Figure 13). DO NOT NAIL THROUGH FLASHING CONE.
Installing Flashing on a Metal Roof
When installing the flashing on a metal roof, it is required that putty tape be used between the flash- ing and the roof. The flashing must be secured to the roof using #8 x 3/4" screws and then sealed with roof coating to prevent leakage through the screw holes. A roof coating must also be applied around the perimeter of the flashing to provide a proper seal.
Storm Collar Installation |
|
Place storm collar over pipe and slide down until | |
it is snug against the open edge of the flashing (see | |
Figure 14). Apply waterproof caulk around the | |
perimeter of the collar to provide a proper seal. | |
Chimney | Waterproof |
Pipe | Caulk |
Storm | Flashing |
Collar |
Figure 14 - Storm Collar
Terminations/Spark Arrestor The fireplace system must be terminated with the listed round top or chase terminations. In any case, refer to the installation instructions supplied with the termination.
CAUTION: Do not seal open- ings on the rooftop flashing. Fol- low the installation instructions provided with the termination
being used. |
| |
| ||
Stainless | Level of | |
Inner Flue | ||
Flue Gas | ||
Pipe |
Storm Collar
Overlap
Outlet |
Flashing
Cone
Nail Only
Outer
Perimeter
of Flashing
Shingles Top and Sides Only
Secure Termination to Outer Pipe with 3 Screws
Waterproof
Caulking
Storm
Collar
Flashing
Underlap
Shingles
at Bottom
Figure 13 - Flashing Installation
Underlap
Shingles
Figure 15 - Termination
www.desatech.com | 11 |