Desa Vm42eP Opening Vent Damper, Spring, Clip Screw Side Front Face Partially Opened Door

Installation

Continued

6.Repeat the process for the opposite door assembly.

7.To adjust the doors, slide them partially open. Using a screwdriver, loosen the hold-down screws in the spring clip (see Figure 34) and pivot plate.

8.Close both doors until evenly joined at the middle and note the gap at the outer edges of the face.

9.Reopen one door at a time and retighten the upper and lower hold-down screws.

10.Repeat the process until both doors are evenly joined, spaced and working freely.

CAUTION: The glass pan- els become very hot while the appliance is operating. Do not attempt to adjust or clean the glass doors until the appliance has fully cooled.

The doors may be removed for replacement or cleaning as follows:

1.Partially open the door and press up on the upper spring clip with a screw driver until the outer top pivot pin is free of the clip.

2.Fully fold the frame assembly and slide the upper edge towards the center of the firebox opening until the guide pins are free of the frame rail (see Figure 35).

CAUTION: Always operate the appliance with the doors ei- ther fully opened or fully closed. Operating the appliance with the doors partially open can re- sult in improper venting of flue products.

Spring	Hold-Down
Clip	Screw

Side

Front

Face

Partially

Opened

Door

Figure 34 - Adjusting Glass Doors

Fold Bi-Fold	Spring Clip
Door After
Releasing
Spring Clip
and Slide
Door Out of	Depress
Upper Track
	Spring Clip
	to Release
	Pivot Pin

Remove Bottom Pin

From Pivot Plate While Pivot Plate

Sliding Door Out of the

Upper Track

Figure 35 - Removing Glass Doors

Opening Vent Damper

Vent damper must be locked in the full open posi- tion before operating the fireplace. If vent damper is not open, fireplace will not light.

	VENT DAMPER MUST BE LOCKED
	IN THE FULL OPEN POSITION
OPEN	TO OPERATE THE APPLIANCE	CLOSE

Figure 36 - Opening Vent Damper

108796-01L www.desatech.com 17