OPERATING FIREPLACE
Continued
TO TURN OFF GAS
TO APPLIANCE
1.Turn off the wall switch.
2.Turn off all electric power to the appliance if service is to be performed.
3.Fully open glass doors if installed.
4.Remove front hearth brick and control access panel.
5.Turn gas control knob clockwise 
to “OFF”. Do not force.
6.Replace front refractory brick access panel.
7.Fully close glass doors if installed.
OPTIONAL REMOTE
OPERATION
Note: The WRC receiver and
1.Turn equipment shutoff valve to ON posi- tion. You can now turn the burner on and off with the
2.Press the ON/OFF button to turn the burner on and off.
| Sensing |
Pilot | Rod |
Burner |
|
| Ignitor |
Inspecting Burners
Check pilot flame pattern and burner flame pat- terns often.
PILOT Assembly
The pilot assembly is factory preset for the proper flame. Alterations may have occurred during ship- ping and handling. The pilot is located on the back right hand side of the burner.
The flame must envelope 1/4" of top of the ignitor/ sensor and grounding stem.
If your pilot assembly does not meet these re- quirements:
•Turn the adjustment screw marked PILOT clockwise to decrease or counterclockwise to increase the flame to proper size (see Figure 37, page 19). Do not remove the adjustment screw.
•see Troubleshooting, page 22
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or floating. Flames should go up through the middle of logset. Flames should not "spill" to the edges of the pan or sides of the logset.
Figure 40 shows a typical flame pattern. If burner flame pattern differs from that described:
•turn appliance off (see To Turn Off Gas to Ap- pliance)
•see Troubleshooting, page 22
Sensing
Pilot 
Rod
Burner
Ignitor/
Sensor
Figure 39 - Correct Pilot Flame Pattern
Figure 38 - Pilot
Figure 40 - Typical Flame Pattern
www.desatech.com | 19 |
