Desa VML27PR To Turn OFF GAS To Appliance, Manual Lighting Procedure, ON/OFF Series Model Ghrcb

16

OPERATING HEATER

To Turn Off Gas To Appliance

Manual Lighting Procedure

Optional Hand-Held Remote Operation

OPERATING HEATER

Continued

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Heater

1.Remove control cover log (see Figure 28, page 15).

2.Turn control knob clockwise to the OFF position.

3.If Using Optional Hand-Held Remote: Let unit cool. Remove all logs from base and set remote sensor selector switch to the OFF position.

4.Replace control cover log (or all logs if removed in step 3). See Installing Logs, pages 13 and 14.

Shutting Off Burner Only (pilot stays lit)

You may shut off the burner and keep the pilot lit by doing one of the following:

1.Remove control cover log (see Figure 28, page 15). Turn

control knob clockwise to the PILOT position. Re- place control cover log.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 52). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the RE- MOTE or ON position when the pilot is not lit. This will drain the battery.

Piezo Ignitor	Flame Adjustment
	Knob

IH		F	PIL
ON			O
	O		T
OFF			O
			N
REMOTE
LO

Control Knob in

Selector Switch in REMOTE Position On Position

(Optional Hand-Held Remote Control)

2.If Using Optional Hand-Held Remote: Use remote control manual OFF button.

WARNING: Make sure remote sensor selector switch is in the OFF position when you are away from home for long periods of time. Follow step 3 under Shutting Off Heater.

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, page 15.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, page 15.

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased sepa- rately (see Accessories, page 27). Follow instructions included with the remote control.

Figure 31- Setting the Selector Switch, Control Knob, and Flame Adjustment Knob for Hand-Held Remote Operation

ON/OFF SERIES (MODEL GHRCB)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 32).

TO LOCK press both buttons on hand-held remote control until light stops flashing. Hand-held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

TO UNLOCK press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

Control Button

Turns Burners

On and Off

NOTICE: You must light the pilot before using the hand-held remote control unit. See Lighting Instruc- tions on page 15.

Figure 32 - On/Off Hand-Held Remote Control Unit (GHRCB)

THERMOSTAT SERIES (MODEL GHRCTB)

The hand-held remote can be operated using either the manual mode (MANU) or thermostatic mode (AUTO) (see Figure 33). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

For morevisit www..com

111115-01D