Product Identification
Grate | Grate | |
Steps | ||
| ||
| Hearth Kit Model____________________ | |
| Serial Number______________________ | |
| Log Set Model______________________ |
Burner
Pan
Burner Clamp |
| |
Burner Manifold | Burner Inlet | |
Fitting | ||
|
Figure 1 - Product Identification (Dual Burner Shown)
Optional Product Features
ON/OFF Safety Valve/Pilot kit and Propane/lp conversion
An optional valve/safety pilot kit with a piezo ignitor is available for this appliance. This system requires no matches, batteries, or other sources to light. You must use this optional system for LP conversion. See Accessories, page 24.
remote control ready (Millivolt) Safety Valve/ Pilot kit
An optional millivolt valve/safety pilot kit with a piezo ignitor is available for this appliance. This system requires no matches, batteries,
or other sources to light. This system may be connected to a wall switch or
Remote Control Accessories
There is an optional
A wall switch is also available for this appli- ance. You must use the millivolt valve/safety pilot kit to use the wall switch with this appli- ance. See Accessories, page 24.
Installation
CAUTION: Do not remove the data plates attached to the burner pan. The data plates contain important warranty and safety information.
WARNING: Before installing in a solid fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creo- sote, ashes and loose paint by a qualified chimney cleaner. Creosote will ignite if highly heated. A dirty chimney flue may create and distribute soot within the house. Inspect chimney flue for damage. If damaged, repair flue before operating heater.
www.desatech.com | 5 |