INSTALLATION

Continued

Hearth kit assembly and Installation

Kit Assembly - Single and Dual Flame

Only

1.Determine which side gas line will be coming into fireplace.

2.Using a hammer and screw driver, remove knockout plug from side of pan that cor- responds to gas line (see Figure 6).

3.Unscrew burner inlet fitting from burner manifold.

4.Place burner manifold in pan with thread- ed opening facing open knockout plug.

5.Using thread sealant (resistant to the ac- tion of propane/LP gas) on larger end of fitting, screw burner inlet fitting through hole and into burner manifold (see Fig- ure 6). Tighten using a wrench. If using propane/LP gas, see Propane/LP Gas Conversion, page 11.

6.Using burner clamp, screw, and nut pro- vided, assemble clamp to pan (“U” style and triple burners only). This will hold burner manifold in place.

7.If using optional GA9050A-1 kit, go to

Optional GA9050A-1 On/Off Safety Valve/Pilot Kit , page 10, for installation instructions. If using optional GA9150A kit, follow instructions included with kit for installation and operation.

SINGLE-BURNER

Burner Manifold

Burner Inlet

Fitting

Knockout Plugs

Burner Pan (Front)

DUAL-FLAME

Nut

Burner Clamp

 

Burner

Manifold

Knockout

Plugs

Burner Pan

Burner Inlet

(Front)

Fitting

 

 

Screw

Figure 6 - Installing Burner

124183-01B

www.desatech.com

9