OPERATIon
Continued
Note: You may be running this log set for the first time after hooking up to gas supply. If so, the control knob may need to be pressed in for 30 seconds. This will allow air to bleed from the gas system.
•If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.
6.With control knob pressed in, push down and release ignitor button. This will light pilot. The pilot is attached to the rear of the front burner. If needed, keep pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match.
7.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob.
Control Knob Pilot
Ignitor
| ON |
| OFF |
|
| FROM "PILOT" POSITION |
| ||
On | SLIGHT PUSH TO | Off | ||
| PULL PUSH | |||
|
| TURN OFF |
| |
ON OFF FROM "PILOT" POSITION SLIGHT PUSH TO TURN OFF PULL PUSH | TO LIGHT | OFF ON POSITION "PILOT" FROM | ||
TO LIGHT | TO PUSH SLIGHT OFF TURN PUSH PULL LIGHT TO | |||
Figure 19 - Ignitor and Control Knob
Thermocouple
Pilot 
Burner
Note: If pilot goes out, repeat steps 3 through 7, page 14.
8.Turn control knob counterclockwise
to the ON position. Burner should light. If burner does not light, call a quali- fied service person.
9.To leave pilot lit and shut off burners only,
turn control knob clockwise 
to the PILOT position.
Figure 20 - Thermocouple and Pilot
TO TURN OFF GAS
TO APPLIANCE
1.Turn control knob clockwise 
to the PILOT position.
2.Press in and turn control clockwise 
to the OFF position.
3.Close equipment shutoff valve.
Cleaning and Maintenance
•Keep the area around the log set clean and clear of debris.
•Occasionally, you may use a soft bristle brush to clean logs.
•Once every year a qualified agency or certi- fied chimney sweep should examine and clean the venting system of the fireplace.
www.desatech.com | 15 |