INSTALLATION
Continued
Installation and Gas Connection
1.Place burner pan assembly in center of fireplace floor. Make sure front of pan faces forward.
2.Thread gas supply fitting to fireplace gas supply pipe. Use thread sealant.
3.Install adapter fitting onto burner inlet fit- ting using thread sealant on male threads of burner inlet fitting (see Figure 7). Adjust to most convenient position.
4.Install gas connector tube to gas supply fitting. Carefully shape tube to attach to adapter fitting. Be careful not to cause kinks in tube.
Gas
Connector
Tube
Burner Pan
AssemblyAdapter
(Facing FrontFitting of Fireplace)
Figure 7 - Connecting Gas to Appliance
Valve/Pilot Kit Assembly
For additional convenience and safety, or for propane/LP conversion, an optional ON/OFF safety valve/pilot kit is available. See Accessories , page 24.
WARNING: You must use a ON/OFF safety valve/pilot kit for propane/LP conversion.
Natural Gas Installation
1.Thread gas control valve onto burner inlet fitting (see Figure 8). Use thread sealant on male threads of burner inlet fitting. Hold burner inlet fitting with a wrench to prevent overtightening connection to the burner. Make sure control rod is facing the front (see Figure 8).
2.Attach pilot gas line to pilot outlet of gas control valve and tighten. Connect ther- mocouple to rear of gas control valve. See Figure 9. Do not overtighten. If us- ing propane/LP gas, see Changing Pilot Orifice, page 12.
3.Install inlet fitting into inlet opening of gas control valve (see Figure 10). Use thread sealant on male pipe threads.
4.Place burner pan assembly in center of fireplace floor. Make sure front of pan faces forward.
5.Thread gas supply fitting to fireplace gas supply pipe. Adjust to most convenient position.
Burner Inlet
Fitting Gas Control
Valve
Burner Pan
Assembly
Control Rod
Figure 8 - Installing Gas Control Valve
Thermocouple
and Line
Pilot and
Line
Gas Control
Valve
Figure 9 - Gas Control Valve with
Thermocouple and Pilot
Gas
Connector
Tube
|
| Gas Inlet |
Gas Control | Inlet | Fitting |
Opening |
| |
Valve |
| |
|
|
Figure 10 - Installing Inlet Fitting and
Gas Connector Tube
10 | www.desatech.com |