® VENTED GAS LOGS
INSTALLATION
Continued
ADDING PAN MATERIAL
1.Open the bag of ash bed material (ver- miculite) and spread it evenly across the burner pan to the top. You may over- flow the front and sides of the pan to cover the entire pan. Do not cover valve.
2.Open the glowing embers and evenly cover the ash bed material (vermicu- lite) in the burner pan.
INSTALLING THE GRATE AND LOGS
1.Place the grate over the burner pan where the two outer horizontal supports on the grate fit into the two pan positioning notches in the rear vertical edge of the pan.
2.Slide the two rear log grate steps over the two outer horizontal supports on the grate as shown in Figure 20.
3.Place the back log on the grate onto the grate steps (see Figure 21).
4.Place the front log(s) on the grate and slide forward against the front bars on the grate (see Figure 22).
5.Place the smaller top logs onto the bot- tom logs (see Figure 22). Leave as much open space between logs as pos- sible to minimize flame impingement and sooting. Note: Logs may chip if they are handled roughly or if hit to- gether while being placed.
Grate | Grate Steps |
Figure 20 - Installing Grate (Pan Material Not Shown)
Manchester Split Oak Logs
Arlington Round Oak Logs
Figure 21 - Installing Front and Back Logs (Number and style of your logs may vary)
| O |
NO | FF |
Figure 22 - Placement of Top Logs (Manchester Split Oak Logs Shown)
OPERATING
APPLIANCE
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas sup- plier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.
12 | 901272 |
