Models FPVF33PRA and FPVF33NRA

INSTALLATION

Continued

WARNING: A qualiﬁed electri- cianmustconnectelectricalwiring to duplex outlet for built-in instal- lation. Follow all local codes.

1.Frame in rough opening. Use dimensions shown in Figure 16 for the rough opening.

2.If using blower, install wiring and properly ground the three-prong, 120 volt electrical outlet in ﬁreplace.

3.Before replacing bottom of ﬁrebox, install duplex outlet to the right support bracket in the bottom of ﬁrebox (see Figure 17).

4.Route wires from electrical box through smallest hole in outer casing using strain relief ﬁtting provided (see Figure 17).

5.Connect wires from the electrical box to duplex outlet. Match wire colors to those indicated on duplex outlet. Be sure to connect ground wire.

6.Install shield to end of right support bracket and behind the ﬁrebox wrapper with 2 screws provided (see Figure 18).

7.Plug blower cord into duplex outlet. Note: On thermostat model ﬁreplaces, route power cord to the back of the ﬁreplace to clear thermostat valve.

8.Replace bottom of ﬁrebox.

9.Install gas piping to ﬁreplace location. This installation includes an approved ﬂexible gas line (if allowed by local codes) after the equipment shutoff valve. The ﬂexible gas line must be the last item installed on the gas pip- ing. See Installing Gas Piping to Fireplace Location, page 13.

10.Carefully set ﬁreplace in front of rough opening with back of ﬁreplace inside wall opening.

11.Attach ﬂexible gas line to gas supply. See Con- necting Fireplace to Gas Supply, page 14.

12.Plug electrical cord into electrical outlet installed in step 2.

13.Carefully insert ﬁreplace into rough opening.

14.Attach ﬁreplace to wall studs using nails or wood screws through holes in nailing ﬂange (see Figure 19).

15.Check all gas connections for leaks. See Checking Gas Connections, page 15.

16.Install brass trim after ﬁnal ﬁnishing and/or painting of wall (see Figure 7, page 6).

17 3/4"

33"

35 1/2"