Desa VYGF33PRC Installation, Operating Fireplace, Continued, INSTALLING 9-VOLTBATTERIES

Models: VYGF33PRC

1 40
Download 40 pages 53.39 Kb
Page 19
Image 19
INSTALLING 9-VOLT BATTERIES

INSTALLATION

Continued

INSTALLING 9-VOLT BATTERIES

Two 9-volt batteries (not included) are required to operate this heater with the wireless hand held remote control set. Install one battery in the receiver and one in the hand-held remote control unit. Note: Only use alkaline batteries.

Installing 9-Volt Battery in Receiver

1.Locate back of receiver under front burner of heater.

2.Locate the battery clip mounted on the back of the receiver.

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Remote

Terminal Wires

Receiver

 

Battery Clip

Figure 36 - Installing Battery in Remote 9-Volt Battery

Figure 36 - Installing Battery in Remote

Receiver

Installing 9-Volt Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to the battery. Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

 

Battery

 

Terminal

Cover

Model

 

GHRCB

Wires

 

 

 

 

 

Remote

 

 

Control

 

 

Unit

Battery

Housing

9-Volt Battery

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

OPERATING FIREPLACE WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, donʼt try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

Model

GHRCTB

Figure 37 - Installing Battery in Hand-

Held Remote Control Unit

113109-01B

www.desatech.com

19

Page 19
Image 19
Desa VYGF33PRC Installation, Operating Fireplace, Continued, INSTALLING 9-VOLTBATTERIES, Installing Battery in Hand